空調移機收氟方法介紹
空調移機收氟方法介紹
Introduction of fluorine collection method for air conditioner relocation
安裝時，打開閥門排空如下:內外機固定后，連接空調，主要是內外機連接管緊密，注意連接，防止制冷劑泄漏。用內六角開關打開自動檔空調，打開高壓閥(細管閥)，用六角頂住加氟口頂針(低壓加氟口)，讓里面的氣體跑出來，10秒左右，不要太久，以免雪種跑得太多，這樣管道里的空氣就可以排出。然后打開高低壓閥門，連接內外機的電源線。
During installation, open the valve to vent as follows: after the internal and external units are fixed, connect the air conditioner, mainly because the connecting pipes of the internal and external units are tight, and pay attention to the connection to prevent refrigerant leakage. Turn on the automatic air conditioner with the hexagonal switch, turn on the high-pressure valve (thin tube valve), and use the hexagonal to hold the thimble of the fluorine adding port (low-pressure fluorine adding port), so that the gas inside can run out for about 10 seconds, not too long, so as to avoid too much snow, so that the air in the pipe can be discharged. Then open the high and low pressure valves and connect the power lines of internal and external machines.
